competition mag holders-need a bit of help

[muddywings]

This is probably best for accessories forum but probably would get my quickest response here.

Being on permanent vacation, until who knows when, thanks to Congress/POTUS, I'm playing with some Kydex. I'm going to try a competition style mag pouch.

Here's where I need 30 seconds of help; can anybody mark how deep the mag sits in the mag pouch then measure from that mark down to the top of the rear of the bullet.
I just need to know how deep a mag sits in the mag pouch.
Just by looking at my first rough draft, I think mine is sitting to deep. Any help is appreciated!

First rough mold:

34779

[ray1970]

I don't understand your question but it looks good so far.

[Beer]

[muddywings]

If this makes sense-just throw a tape measure down inside a CR Speed or DoubleD mag pouch and measure to the top of the pouch.

Mag pouch like: http://www.shootersconnectionstore.com/CR-Speed-Versa-Mag-Pouch-P197.aspx

ETA:

NM-took a stab at it. Think I'm good to go. Mods, you can toss this or throw it in the accessories forum.

Prototype complete:

http://i.imgur.com/bfmvRnp.jpg?1

http://i.imgur.com/6VGfRFq.jpg?1

http://i.imgur.com/I3GrJZ6.jpg?1