FL resizing die scoring neck?

[CS1983]

I was about to make a run on some brass tonight when I noticed on the first few that the necks were exhibiting a scoring symptom.

Took apart the die and cleaned it, and looked inside with a flashlight to see if I could find any roughness, but everything looked fine.

The scoring has a very, very slight step leading to the case body, but running perpendicular it's noticeably ridged.

Has anyone seen anything like this before? Is it a problem or just a cosmetic issue?

66321

Die: Forster FL NM

[Jamnanc]

Yes, clean it better with toothpaste and a good scrub.

[CS1983]

Ok. Looking around some more, it seems others have had the same issue at times and it means the die needs to be polished. Guess I know what I'm doing tomorrow after work.

[Hoser]

Steel wool wrapped around a brush and a cordless drill are what you need.

And don't forget to use lube, even when you are just neck sizing...

[CS1983]

Thanks for the replies. I picked up a .30 cal bore mop and some 0000 steel wool; chucked it on the drill and spent ~7 minutes just polishing at high rpm. The cosmetic aspect is still there, but I can't feel anything when I scrape over it.

Now have a bunch of .308 brass that's ready to be primed :D

[Jamnanc]

I am sure Redding will replace/repair it if you get time to send it back.

[jmg8550]

My RCBS dies do the same thing. I'm not concerned with it, it polishes out of the brass easy enough when tumbled.