Anyone near Parker with a cutting torch?

[rondog]

Looking for someone in Parker, Franktown, Elizabeth or Kiowa with a cutting torch. Very quick, simple job - I have an AR500 steel target plate and need the hanger hole enlarged. That's it! Will trade for a 6-pack of your favorite frosty beverage.

If I could stop by Sunday on my way to BLGC, that would be perfect. I have a torch set, but the oxygen bottle is empty. For what an exchange would cost, I could get 3-4 more AR500 plates, and then it wouldn't get used again for who-knows-how-long.....

[BushMasterBoy]

Plasma torch would work too. You are just too far away.

[rondog]

Plasma torch would work too. You are just too far away.

Yeah, that's a haul!

[BushMasterBoy]

I was there Wednesday and would have brought the torch. oh well.

[rondog]

No worries, we have a lot of members in these four towns. If nothing else, I'm sure the caretaker that lives out at BLGC has one.

[Grant H.]

Probably farther than you want to go, but I have both Plasma and Oxy/Acet outside of Boulder.

[Wulf202]

A cutting torch will mess up the heat treat much more than a plasma.

[asmo]

I got a dremmel and a bunch of cut off wheels.. Same thing, right?[ROFL1]

[brutal]

Just leave it at the range for a week, it will be full of holes.

[thedave1164]

Just leave it at the range for a week, it will be full of holes.

LOL, truth.

Yeah, I have both too, but the wrong direction for you

[rondog]

A cutting torch will mess up the heat treat much more than a plasma.

I'm only wanting to open up the bottom of the hanger hole, not concerned about the heat treating of the whole plate. Won't hurt it any.

Dammit, I wish I knew why I can't upload photos from my phone anymore, never used to be a problem.....only seems to be with photos taken WITH my phone.

[rondog]

Still need this done.....