XJ
04-23-2007, 22:16
I tried comparing on Gunbroker and the auction sites, but got confused on how the parts mix affects value.
Springfield Armory M1A, Asking 1600.00
USGI parts as follows :
* Winchester Barrel, measured TE of less than 1
* Winchester Op-Rod, purchased new from Elmer Balance, used very little
* Winchester Bolt
* Trigger Group, housing 7267030-HR-N, Hammer C46008-3 SA
* Rear Sight , WCE
* Gas Cylinder and Piston
* Forged Flashhider w/ bayo lug
* Wood Stock, super clean shape
Other Parts
* Sadlak NM Spring Guide.
* Extra Flashhider no bayo lug
* Fiberglass stock and handguard ( painted Olive )
* Assorted disassembly tools
* 20 rd USGI mags , 6 marked BRW S-1, 2 Type 57 mags
* 1 5 rd Springfield mag
* Factory Box.
* Extra USGI Recoil Spring
Gas System has been shimmed to tighten it up
Will ship to FFL, buyer pays actual shipping.
Springfield Armory M1A, Asking 1600.00
USGI parts as follows :
* Winchester Barrel, measured TE of less than 1
* Winchester Op-Rod, purchased new from Elmer Balance, used very little
* Winchester Bolt
* Trigger Group, housing 7267030-HR-N, Hammer C46008-3 SA
* Rear Sight , WCE
* Gas Cylinder and Piston
* Forged Flashhider w/ bayo lug
* Wood Stock, super clean shape
Other Parts
* Sadlak NM Spring Guide.
* Extra Flashhider no bayo lug
* Fiberglass stock and handguard ( painted Olive )
* Assorted disassembly tools
* 20 rd USGI mags , 6 marked BRW S-1, 2 Type 57 mags
* 1 5 rd Springfield mag
* Factory Box.
* Extra USGI Recoil Spring
Gas System has been shimmed to tighten it up
Will ship to FFL, buyer pays actual shipping.