Log in

View Full Version : OK door guys. How do I fix this?



Sparky
04-12-2013, 15:24
I am renting from some not so nice people so I want to spend as little as possible. My kids did this slamming into the door so it is my fix.

http://i.imgur.com/P2LcI06.jpg?2

cjmore
04-12-2013, 15:35
Short of doing it the right way, replacing both trim board and jamb...Bondo. Mix bondo fairly thick, I'd screw a couple boards to either side to form it up and I'd start with the lower half. Let it set up over night and them do the upper half. If you really want to get fancy put a couple short nails in the wood sticking out but below the final surface giving the bondo another area to hold to. Paint and it'll hold for inspection or until the next person kids the door in I mean "slamming the door in"

WETWRKS
04-12-2013, 15:36
That will buff right out

ChunkyMonkey
04-12-2013, 15:38
Post a gun free zone outside the door and you won't have to worry about the lock any longer!


Sorry I wish I could be more useful.

Byte Stryke
04-12-2013, 15:47
let your character reflect your actions...
does it matter that the landowners aren't nice? exactly what is the formula for that? Nice/damage=responsibility?

fix it right.

griebel303
04-12-2013, 15:48
I am no door expert, more of a weekend diy'r but I had an interior frame broke like that when I moved into our house. Depending on the frame, you might be able to get the piece you need from the Home Depot. They sell individual pieces of the frame you use to replace it :

http://www.homedepot.com/p/t/202089243?catalogId=10053&langId=-1&keyword=door+frame&storeId=10051&N=25ecodZ5yc1vZ12kyZ12kx&R=202089243#.UWiAz7WbNR0

http://www.homedepot.com/p/t/203111823?catalogId=10053&langId=-1&keyword=door+frame&storeId=10051&N=25ecodZ5yc1vZ12kyZ12kx&R=203111823#.UWiAzLWbNR0

They also sell just the flat piece without any trim on it for like $8, which is what I used. Pop the trim off the front on the broken side and then you get access to the nails anchoring. Saw those off and then you knock out the shims which will help with wiggle room for the top of it. Then saw any at the top that you can, where the top piece joins the side. Once you get that off it shouldn't be too hard getting the new piece in. A little bit of a pain to get just one side off the frame, but with a saw zaw and a drill you can make it look pretty good. Hope that helps a little?

soldier-of-the-apocalypse
04-12-2013, 15:58
DUH duct tape

griebel303
04-12-2013, 16:01
Solider of the apocalypse might be onto something here. Duct tape and white spray paint haha

Sparky
04-12-2013, 16:08
I was just referred to this site

http://armorconcepts.com/fix-a-jamb/#all/1/list

generalmeow
04-12-2013, 16:13
I was just referred to this site

http://armorconcepts.com/fix-a-jamb/#all/1/list

That doesn't look like a bad plan, but you'll still want to glue/nail back the piece of broken wood under it. And make sure you get the model with a latch and deadbolt cutout. And measure them to make sure they'll line up.

newracer
04-12-2013, 16:14
use liquid nails liberally and put the piece of wood back. use finish nail gun or wood screws to secure it. once it dries it will be good to go.

If you have all the pieces and can put it back together like a puzzle I would do this. Except I would use regular wood glue or Gorilla glue. I would use finish nails over wood screws.

SuperiorDG
04-12-2013, 16:16
I am no door expert, more of a weekend diy'r but I had an interior frame broke like that when I moved into our house. Depending on the frame, you might be able to get the piece you need from the Home Depot. They sell individual pieces of the frame you use to replace it :

http://www.homedepot.com/p/t/202089243?catalogId=10053&langId=-1&keyword=door+frame&storeId=10051&N=25ecodZ5yc1vZ12kyZ12kx&R=202089243#.UWiAz7WbNR0

http://www.homedepot.com/p/t/203111823?catalogId=10053&langId=-1&keyword=door+frame&storeId=10051&N=25ecodZ5yc1vZ12kyZ12kx&R=203111823#.UWiAzLWbNR0

They also sell just the flat piece without any trim on it for like $8, which is what I used. Pop the trim off the front on the broken side and then you get access to the nails anchoring. Saw those off and then you knock out the shims which will help with wiggle room for the top of it. Then saw any at the top that you can, where the top piece joins the side. Once you get that off it shouldn't be too hard getting the new piece in. A little bit of a pain to get just one side off the frame, but with a saw zaw and a drill you can make it look pretty good. Hope that helps a little?

This ^^^
And the "D" stands for Door.

spongejosh
04-12-2013, 16:23
Wood glue, the broken out piece(s) and screws.

generalmeow
04-12-2013, 16:34
If it were me, and I'm a very handy guy, I'd glue/screw it, and I'd finish the shit out of it so you'd never be able to tell. But this would probably be the worst option if you're not picky and can't make it look right. I'd make sure the strike and deadbolt plates were solidly anchored into more than the flimsy door jamb.

If I were recommending to a friend who is not handy at all, the armorconcepts thing doesn't seem hard to install, and it will do the job very well (the latch and deadbolt should be very solid). I don't know what it will look like when it's done though. Maybe it will look fucked up to the landlord.

If I were the landlord, I'd want you to replace the jamb. I wouldn't accept option A, because I wouldn't believe you could make it so I couldn't tell. And I wouldn't want option b because it will look like we have a security problem, or somebody kicked in the door.

StagLefty
04-12-2013, 16:55
When you put it all back together use at least 2" screws for the plates to get into the 2x4 framing or else you'll have the same repair to do again.

Squeeze
04-12-2013, 17:26
Hire this guy. Problem solved. You're welcome.

/BdqM8WvDnp0 (http://[youtube]/BdqM8WvDnp0)

baglock1
04-12-2013, 17:32
let your character reflect your actions...
does it matter that the landowners aren't nice? exactly what is the formula for that? Nice/damage=responsibility?

fix it right.

This. Is your integrity worth the cost to fix it right? You said it was your kids that did. Time to man up and accept responsibility for it.

brutal
04-12-2013, 17:50
Flexseal.

If it was their interior bedroom door, I would offer prevention advice. Remove the door from the hinges and store away. The little bastards hate that shit. Ask me how I know.

Sparky
04-12-2013, 18:01
Flexseal.

If it was their interior bedroom door, I would offer prevention advice. Remove the door from the hinges and store away. The little bastards hate that shit. Ask me how I know.

You are not the first dad to do this.

brutal
04-12-2013, 18:03
You are not the first dad to do this.

No doubt.

Had a friend do it after mom caught the young lad rubbing one out. He kept doing it without the door so they just put it back on.

[LOL]

Sparky
04-12-2013, 18:16
No doubt.

Had a friend do it after mom caught the young lad rubbing one out. He kept doing it without the door so they just put it back on.

[LOL]

My oldest daughter told me to get out of her room and slammed the door. Once