Does anyone know who does engraving that would not mind doing some custom engraving on an AR15 Magwell? Thanks
Printable View
Does anyone know who does engraving that would not mind doing some custom engraving on an AR15 Magwell? Thanks
Subbed, I too need this work done.
Damn, I just talked to a guy last week about this very issue... I can't remember who/where, but I believe it was in CS- I was a bit down because I was looking in Denver, so I'll ask him again and let you know.
The Trophy Shop in Pueblo does an outstanding job. PM Larry Ashcraft here on the board.
Thanks!
A denver place just quoted me a custom job. setup + 2 magwells engraved $100. Seems reasonable. I'll Post pics if you want when they done.
Here is the breakdown:
My one Receiver for the magwell engraved is total of $90. I think that is pretty fair. She said the second one is going to cost me another 40 because the graphic is already created with the first one.
The minimum cost to engrave a gun part is $50.00 which covers text only in one area. The total cost for engraving would vary depending on how many areas they want engraved and whether they want just text or text plus an image and how much work I have to put into creating the image they want. I can give actual quotes once I see what they want engraved, what area the engraving is on and how large the engraving will be. Here is a breakdown of base charges for engraving on gun parts:
Laser Set up Fee: $30.00 per area of engraving
Text Set up Fee: $10.00 per area of engraving
Image Set up Fee: $40.00 per image but could be more depending on what I have to work with
Laser Fees: $10.00 per area, could be more if the area is larger
I can only engrave on flat areas (not the barrel etc) and the gun part must be able to fit in the laser – no longer than 36”.
I'll post pics when done... I am dropping it off on the 6th.
Hiya!
This is what I got back! I was VERY pleased... turnaround was 48 hours, and total from graphic design to getting it engraved. 90 bucks!!! Plus Mary was very nice and wanted to make sure I was pleased!
http://i995.photobucket.com/albums/a...s/DSCI0642.jpg
I highly recommend [FONT='Arial','sans-serif']www.CustomLaserDesign.com[/FONT]
Robert
12/1/20 UPDATE, Mary is great!! pix below and two day turnaround. Resized the graphics I gave her by computer file to best fit. Will use her for all my engraving.
Attachment 84125 11/23Attachment 841264/20 Just emailed Mary at www.customlaserdesign.com Prices were more than fair, dropping off lowers right after Thanksgiving, will update post and put up pix afterwards...... Thanks for the RKI guys and gals on this forum.......