Printable View
I'm looking to get a sight/scope for the new sig 556 I bought, the eotech does not clear the charging handle enough for my liking, any recommendations? I've been looking into the trijicon tri power? or maby the 2x acog, I mostly use it for coyote, or varmint shooting, 99% of the shots are under 200 yards? TRIPOWER
buy a riser. the acog may not clear too. theres not much difference width wise between them.
i have an aimpoint on mine. i still get my fingers caught. thats the only down fall that i have found with the gun. i would just get the one you like the most
http://i150.photobucket.com/albums/s...l/IMG_0006.jpg
also have you taken your hand gaurds off yet? i have tried doing what it says in the manual but im worried im going to break something with to much force. if so any tricks?
yep, just go easy when pulling off the top handguard, pull back before pulling up you should have no trouble.
http://i223.photobucket.com/albums/d...01-07_2012.jpg
I'm thinking i've narrowed it down to two, its between the acog, and the new bushnell.
http://bushnell.com/general/rangefin...ection=Hunting
http://www.trijicon.com/user/parts/p...2&categoryID=3
after some serious internet bargining, and several phone calls, I found and ordered the acog 4x32 ta01nsn. I think I got a sweet deal over $300.00 off retail, now off to bed so the buyers remorse dont kick in.
http://www.trijicon.com/user/parts/p...4&categoryID=3
ok i have been fighting this thing for an hour now and cant get them off. the top hand gaurd slides indendantly from the bottom one right? because mine will only move together. im sure im missing something stupid but i cant figure it out. i have the gas system removed but not the outer tube. that comes out after handgaurd removal, yes? i can get both pieces to slide all the way back until they make contact with the reciever.
mine might be a little picky as i have one of the very early models. first 250 made and have heard of people having troubles. any suggestions?
you have the upper and lower seperated correct? ( a pia to do using two screwdrivers)
no i don't. you have to pry them apart? is that what those little slots are for?