-
BPTactical it will be then.
My sizing die is a Dillon RT1200 setup on a Lee LoadMaster - bottomed out on the shellplate. No problems with the first 4k that I have made, it's just this last batch. Might be that I need to have .005 - .010 trimmed off my die base for a little more fluff room.
Last night I went through 500 rounds and culled out 25-30 that were .006 or less above my case gauge max - those were causing a FTF and stuck bolt. Even the ones that are flush with the case gauge max require a fairly stout pull to release the bolt. I need to go through another 300 or so to finish my training class....Yes I am firing this rifle for this class. Not wise? likely, but I want to learn how to run a scoped DMR in a tactical CQ situation. PRS stocks bite back when you have to mortar them.
-
Best steps to start from scratch on an AR build
-
Go see Bert @ B&P Tactical. He is the best gunsmith I've dealt with ever.
-
TD2 went without a hitch, except for having to double handed pull a couple for manual unload/extraction. Might have had a few sneak by that were a tad over max length.
This may turn into a deal with it during lay off. Going to try for next weekend. Will make some calls.
