Hot glue sticks work reasonably well, either cut or injected in bullet molds. LEGO heads work in 40SW.
Printable View
Hot glue sticks work reasonably well, either cut or injected in bullet molds. LEGO heads work in 40SW.
Printed a 45acp round. Was a tight fit at first, probably due to the layer start points (little extra at each start). Once I chambered it once, it was fine. Didnt undersize at all. Did 5mm of solid base, then 25% infill. It is within .003" of perfect round.
Quote:
Originally Posted by 00tec
Didn?t mess up the rim or anything ejected just fine?
Sent from my iPhone using Tapatalk
Ejected fine. Kinda surprised. I'm just using cheap Microcenter PLA. Ran it through the glock a few times, not even marking bad.
https://photos.app.goo.gl/pqmLkykB9cxyxfw8A