What did you do in the reloading room today?

Quote:

---

Originally Posted by Great-Kazoo

So, you deprime on one unit, then size with this machine, correct?

---

No need to deprime prior to roll-sizing.

Tumble clean, roll-size it and then load it on my 1050.

Got the portable ac/heat unit set up and running today. Tomorrow i plumb in the utility sink.

Roll sized and processed a bunch of 223 and 308 for a member here. When you add roll sizing to a carbide trim die, life is so much easier.

Also got a little bit of full power 470 Nitro ammo loaded for myself. About 102 gns of H4831 under a 500 gn bullet makes for a good time. Not nearly the harsh recoil of a 458 Lott or 460 Wby.

Just sellin' brass on another forum, gathering gun safe funds.....

Quote:

---

Originally Posted by Hoser

Also got a little bit of full power 470 Nitro ammo loaded for myself. About 102 gns of H4831 under a 500 gn bullet makes for a good time.

---

102 grains?

Ah, loading with a shovel for a powder measure....

Quote:

---

Originally Posted by Hoser

Also got a little bit of full power 470 Nitro ammo loaded for myself. About 102 gns of H4831 under a 500 gn bullet makes for a good time. Not nearly the harsh recoil of a 458 Lott or 460 Wby.

---

You are a sick, sick man..... [Coffee]

I like the roll-sizer machine, but it's a bit pricey.

Quote:

---

Originally Posted by Duman

You are a sick, sick man.....

---

Just because I can, I loaded up 10 rounds with 115 gns of Retumbo. Should make for an impressive fireball.

Ill be in my bunk....

Updated the software on my AMP annealer and AMP-Mate. Back to the races there while I plow through processing this 5 gallon bucket of 223 brass for a forum member.