Hell its only -2 here. Nothing like frozen nostrils in the morning!
Printable View
Hell its only -2 here. Nothing like frozen nostrils in the morning!
What a bunch of whiners.
I grew up in GB WI.
Ya'll aint' got nothin on that cold.
P.S. That's why I live out here now. :D
Mmmmmm cheese. ;)
Sven where you been?Quote:
Originally Posted by brutal
Lobbed from my electronic ball and chain
Drilling holes in the ice with Ollie.Quote:
Originally Posted by buffalobo
:thumbup: How is Ollie? You guys catching Sturgeon or Muskie?
Lobbed from my electronic ball and chain
I actually thought it was 13* and wondered how the weather folks snookered everyone to believe it would be sub-zero. Till i put my glasses on , then noticed the -13Quote:
Originally Posted by Great-Kazoo
FIFYQuote:
Originally Posted by mcjhr
HotHands on the sack.....problem solved!
Well, initial impressions of Worlds Finest Trimmer .223 Rem
1) You don't need a 1/2" drill for the .223. It has a 5/16" End Mill as the cutting tool, so a 3/8" works just fine.
2) Holding the drill and the brass is not the best way to do this. Need to use a vice to hold the drill, turn it on and then you can run your brass.
3) Setting it up to cut 1.745" is a PITA. I used a piece of brass that was 1.745", followed the directions to set it up. Grabbed a piece of brass that was 1.762", trimmed it, marked the rim with a sharpie to see if it was trimming any further, trimmed it and only sharpie on half of the rim came off, so I trimmed it again and spun the case, same thing. Okay, that piece of brass is at 1.745". It measured 1.755". Not even CLOSE to 1.745". There is definitely a trick to setting it up or something, because that piece of brass would never trim below 1.755" But, I don't have the time now to figure out a better way of setting it up, so, this is all the review you're getting for the moment HB.