Printable View
Check out the Yeti grips for the Scorpion. I have the Everest on mine and it's much better. It's not perfect IMO but will do until something better comes out.
I just threw a MRO on mine as well. My favorite so far. I'm running some Troy micro flip ups for irons too.
Still haven't filed, or finished? That SBR looks good.Quote:
Originally Posted by Jer
Yeah, I'm aware. Those are exactly the ones I'm talking about and I refuse to pay $50 (actually, it's $60 plus shipping so call it $75) for 3D printed grips that don't even match the same color as the Scorpion itself. I'm not in that big of a hurry so I'll just wait and see if someone comes out with something injection molded, cheaper or both.Quote:
Originally Posted by cfortune
I was considering going to some micro flip ups as well but I kind of dig the stock sights. Not sure yet but I've been considering going that route and leaning that way more so now that I've finally found an RDS I like on this firearm.
Thanks man, I dig this thing.Quote:
Originally Posted by Great-Kazoo
Nope, I haven't done anything yet but I'm going to probably be moving that project from the back burner to a more centralized burner that's easier to reach. Maybe even the front burner but I dunno. We'll see. ;-)
I can't even see what the gun looks like past that American flag friendship bracelet you've got on the hand guard.
http://endlesspicdump.com/original/h...ameritrain.jpgQuote:
Originally Posted by Irving
I hear ya on the grip. They're over priced. I think mine was $64 shipped. They leave a bit to be desired in the abrasive department as well. The color actually does match fairly well. They look purple in most photos but they aren't.Quote:
Originally Posted by Jer
I have the ADM low mount and with the Troy sights, the rear aperture is almost at the top of the optic. It's like an upper 1/3 co-witness lol. I thought the factory front just ate up too much real-estate. However that was when I had a PA reflex on it. Doesn't seem to be nearly as much of an issue with the MRO. I'd save the $100 if I could do it over again and not get the Troy micro sights.
https://uploads.tapatalk-cdn.com/201...5cfe756bb8.jpg
In case you were curious.
Good to know. I've done the lighter trigger springs & polished all the contact points while I was in there changing the springs and the disconnect as well as the right ambi-safety delete and a couple other mods that are slipping my memory right now aside from what you can see in the photos. On the list yet is a dedicated Form 1 titanium suppressor and most likely the forend from the new Scorpion Carbine as that will eliminate the cheese graters and it looks like I can get a suppressor to fit inside of it still. Not sure yet if I'm going to go as far as adding a light and sling but maybe. A decent grip with a more steep angle would be a nice thing to have too but I'm not overpaying for 3D printed products so I'll just cope for now.
Looks like we need a Scorpion thread! Been thinking about one of these. Might have to move it up the list.