Arsenal SAM7K-03

Looks like Arsenal has made some nice improvements to the original SAM7K pistol. Anybody have/shoot one yet?

http://www.arsenalinc.com/usa/SAM7K-03-PISTOL.html

http://www.arsenalinc.com/usa/images/D/SAM7K03ai.jpg

If they weren't so proud of their product, i'd buy one and SBR it. Hard to do when i SBR'd my draco, $400 draco $200 stamp.

Quote:

---

Originally Posted by Great-Kazoo

If they weren't so proud of their product, i'd buy one and SBR it. Hard to do when i SBR'd my draco, $400 draco $200 stamp.

---

How hard to SBR? Do you just need to get a different rear riveted on the receiver.

Quote:

---

Originally Posted by USMC88-93

How hard to SBR? Do you just need to get a different rear riveted on the receiver.

---

i drilled & tapped 2) 8-32 holes for an ace adapter, little red loc-tite put, installed US mfg H/T/S flash hider, ace folding stock, pistol grip, MI handguards. Install loaded mag shoot & repeat. With the short bbl, yo would think the recoil might be a little noticeable. There's minimal recoil, for what there is.

Attachment 49587

Attachment 49589

Same way I did my PAP m92.
Attachment 49595

Quote:

---

Originally Posted by balyon885

Same way I did my PAP m92.
Attachment 49595

---

I'm thinking of shit canning the MI hand guards, going with an AMD refinished set by BOBBYZZZZZZZZZZZZZZZZZ. I have a cut up wood butt ,stock. IF i was the master wood workerike we we have here, i'd figure a way to put it on, instead of the black furniture.

Was a pain to get it to that, but I used the citrus strip, an iron, and a dark stain with some oil sealer over it. Took me a few tries and it never got as dark as I was hoping for. The only handguards that fit the pap are mi's and I wasn't going to pay that price.

That m92 looks bad ass!!! Nice job.

Quote:

---

Originally Posted by Great-Kazoo

I'm thinking of shit canning the MI hand guards, going with an AMD refinished set by BOBBYZZZZZZZZZZZZZZZZZ. I have a cut up wood butt ,stock. IF i was the master wood workerike we we have here, i'd figure a way to put it on, instead of the black furniture.

---

We can fix that ;)
Just have to figure out how to graft the buttstock onto the folding mechanism and were golden :D

Quote:

---

Originally Posted by zteknik

We can fix that ;)
Just have to figure out how to graft the buttstock onto the folding mechanism and were golden :D

---

Well after bouncing ideas off each other i will proceed as talked about. I really don't need the amd stock. Make my own base and mount, BAM! With the scope mount and charging handle interfering it will not side fold 100% . BUT it's all about the individuality. I could use a 10/22 or sks back section ,mmmmmmmmmmmmmmmm