I'm putting a new barrel on an old Mauser action and will be cutting it down to desired length, does anyone have experience with or preference for a barrel crowning tool that doen't require a lathe? [Help]
Thanks
Printable View
I'm putting a new barrel on an old Mauser action and will be cutting it down to desired length, does anyone have experience with or preference for a barrel crowning tool that doen't require a lathe? [Help]
Thanks
Check this out. It SEEMS pretty easy!
http://www.youtube.com/watch?v=Z-y8lNlnLMM
Quote:
Originally Posted by OneGuy67
Bubba at his best to be sure!
He can't hold a candle to you, my friend! But, if one was interested in trying it out for himself, it seems like it isn't that hard to do...!
I'll bring you the rifle after I screw it up!
The disillusionary thing about that vid-for what he has invested in the crowning tooling it is probably more cost effective to have a Smith do it for a single rifle. If you are doing multiple rifles then the cost of tooling to do it correctly (lathe) becomes prohibitive.
Sounds like good advice after watching the vid, I don't need all that tooling for a one time deal.Quote:
Originally Posted by BPTactical
Saw-zaw.[Stooge]
Quote:
Originally Posted by SA Friday
Hack!
Pipe Cutter[Coffee]
Don't forget the reamer to clean up the burr after the pipe cutter.Quote:
Originally Posted by BPTactical
Jus' waller it out a bit with an undersized drill...[Help]Quote:
Originally Posted by SideShow Bob