Printable View
Pivot pin detent is driving me nutz...just lucky I haven't lost a detent or spring yet!!!
I'd rather slam my d#ck in a door multiple times than deal with this again. I wish I would've researched the clevis or Brownell tool first. Or I should've taken the lower and LPK to BP for no headaches.
Geez, what a PITA. Guess I'll head to Home Depot tomorrow to try the clevis route.
Drew
Try using a punch to hold the detent in place before inserting the pivot pin.
Put the receiver into a clear bag, then assemble if it goes flying it will be in the bag
Or you can come over here with a magnet and find some [Beer]Quote:
Originally Posted by henpecked
If you haven't already you should watch some YouTube video on building lowers.
Yep, did both. The bag work for the intended purpose. I used one of our large "vacuum seal bags" that we use to store quilts and comforters long-term. It saved by butt the first 10-15 times for sure.
Additionally, I tried using a punch and a hex to hold the detent while feeding the pivot pin with no luck. The biggest problem is getting the detent started and then holding it until tool is in place to hold it.
Some of the videos I watched made it look simple but seemed different than my set-up. One guy was actually able to rest the detent on top of the spring without applying pressure. My first thought was "he trimmed the spring so that he could make a bogus youtube video and look like a hero".
Maybe it depends on the LPK but it ticked me off every time I watched that video. Oh well...it was super late and I was super frustrated because I know it can be done. I'll tackle that SOB today for sure.
Buy the clevis pin, have it done in 45 sec.
Wow...that $1.57 Clevis is the best. Wish I would've had that last night!!!
Took maybe 90 seconds max.
Thanks for all the help and input
I use a piece of .250 drill rod. Works like a charm.
Anything else results in Tourettes Syndrome.
Phoenix Weaponry Billet lowers have a set screw instead of the detent. Makes putting an LPK in really easy.
Color me surprised.Quote:
Originally Posted by Zachg0311
I'm having trouble picturing how they use a set screw for the pivot pin.Quote:
Originally Posted by Zachg0311
They don't have a set screw for the pivot pin but they have one for the bolt catch and also for the rear take down pin.
I use a thin piece of something sturdier than paper. For example, a price tag or something like this:
http://cdn2.thegrindstone.com/wp-con...97-300x200.jpg
I put the spring in, then the detent and push it all down with the tag (or whatever you're using). It's so thin, it lets you slide the pivot pin right over it and you can just slide the tag out once the pin is in. Just make sure whatever you're using is strong enough not to tear when you use it to push the detent down.
I just built one using a razor blade in a utility knife, worked like a charm. It took about 45 sec.
Griff
I use an old flat thin butter knife. Takes less than a minute. It is a kind of get the hang of it thing.
http://www.academy.com/webapp/wcs/st...%5E70247940318
or a clevis
or build your own clevis
or go insane.
You have choices.
You left out the most important part...Quote:
Originally Posted by SA Friday
.....being smarter than the part your working on[Coffee]
I won't even hedge a guess as to how many of those little fucking detents are in the carpet and under the bench at Bowers. Only second to dust cover c-clips.Quote:
Originally Posted by BPTactical
Me too. I use a small pair of needle nose pliers to hold detent above spring then push down with razor blade and slide pin in. Works great!Quote:
Originally Posted by Griff79