Printable View
So, with today's awesome winds, my furnace is inop. I believe it is due to differential pressure causing it to shut down to prevent CO problems.
I have the fresh air intake and furnace exhaust on the back of the house. Both are 4" and turned facing down.
Any suggestions? Temp is dropping at home and I'm fresh out of ideas to get it running.
Stand in front of the vents and block the wind?
Seriously, it may not even be weather related. I’d likely start with the simple stuff. Filter clean? Batteries in thermostat good (if equipped)? What about the flame sensor?
Good luck.
Tell us the facts. Make, model, trouble lights, what you've tried etc
Thermostat is a Nest, fully charged, reporting no errors. Nest is currently set to heat. and is reporting a valid attempt to do so.
I think the furnace is a Nordyne or something (wife is home, I am not). Solid red LED, blinking green (no pause).
Fan runs, but burner will shut down after firing for just a few seconds.
Furnace came new with house less than 1.5yrs ago.
Clean your ignition sensor first with some sand paper
flame sensor.. Clean it and you'll be working right.... Then get rid of that stupid Nest... They suck and I hate them..
If you want a Wi-fi talk to me and I'll get you set up. Just stay away from those Nests... They suck and I hate them.
Yep, flame sensor, had to clean mine this year, some emery cloth and then wiped it down with some alcohol. Good as new
Wife reported that the furnace just kicked on, the winds have died down a bit at the house.
Sounds like you weren’t getting enough pressure differential across the draft inducer switch. We had our pressure switch go out last year. The furnace would get the “on” signal, the draft inducer motor would turn on, but with the switch not working it would shut the whole thing down.
What sloshed out of your glass while cleaning it ?Quote:
Originally Posted by thedave1164
Same way I clean my windshield.Quote:
Originally Posted by SideShow Bob
EverclearQuote:
Originally Posted by SideShow Bob
I can't see through a Bloody Mary...Quote:
Originally Posted by Irving
Tell that dunk beech to get off your windshield, unless................................Quote:
Originally Posted by spqrzilla
If this were the case it would not have fired at allQuote:
Originally Posted by Jeff350
It is possible that it was not firing at all. She may have heard the draft fan kicking on and thought it was the burner.Quote:
Originally Posted by Wulf202
It has been fine since.
I believe the flue is getting a ram air effect due to how it is positioned and angled.
Attachment 73750
This thread was a good reminder for me to buy a spare hot surface ignitor to have on hand . . . arrived today.
And then . . . when I went to put it in the furnace room, I found the other spare that I forgot I had. Better to have one too many, I suppose.
Is that considered a case of 2-is-1 and 3-is-2?
I was told there would be no math.Quote:
Originally Posted by kidicarus13