Printable View
How do you put the basterd on! In the instructions it says to simply twist off my old A2 flash hider and thread the new JP. My A2 Flash hider, just doesn't twist off... Do I need to put a screw driver and twist the basterd off or is there an easier way?
Any chance it's got loc-tite on it ? I used a strap wrench to hold the barrel and a crescent on the flash hider once I got it to move it came right off.
not a lot just enough to warm up the loc tite if there is some. it will warm up fast if was used, and then it should turn off. or not
Could be pinned and welded... Bring it to Pueblo tomorrow and I will give it a look.
How long is the barrel you're removing the A2 from?
Wow that was a ******. Had to find a 3 foot Fence pole Duck tape the wrench on it and use leverage to get that basterd off. But its done, Thats the good news, the bad news is I Scratch the metal finish on both my barrel and the comp [Rant1] lesson learnt, only use right size Wrench's and not adjustable pliers when tighting Comps on muzzles.
Couple questions though
Do I need to re-zero since I technicelly changed the barrel design?
If its not 100% strait, will it throw off my aim a bit? I'm pretty sure its where its suppose to be but i dont' have a barrel lvler.
Kids...
Bring it by WPGC Friday night and I will look at it.
lol, sure.Quote:
Originally Posted by Hoser
WPGC ? What's that? (Newbie here)
whistling pines gun club.Quote:
Originally Posted by theGinsue
OMG!
when you don't know what you're doing, ask and when the solution is offered for free.. take 'em up on it!!!!!!!!!!
ALWAYS use the right sized wrench!
would be a great idea to check your zero.. you did change the bbl physics