What did you do in the reloading room today?

[gnihcraes]

unboxed and setup my new RL550B.

I think it is finally working properly. Been a struggle to get the primer actuating rod to function correctly, keeps sticking.

[Great-Kazoo]

unboxed and setup my new RL550B.

I think it is finally working properly. Been a struggle to get the primer actuating rod to function correctly, keeps sticking.

Loosen the allen heads on the primer housing . Pull handle down so the primer cup is in shell plate. Then tighten the screws. Another minor issue is the large roller on the primer slide not moving when and where it should. I use a quick blast of silicone spray on the pin.

[Hoser]

Been a struggle to get the primer actuating rod to function correctly, keeps sticking.

Back off the two screws that hold the primer assembly to the frame. Just a touch, like less than 1/8 of a turn.

Also, try running some 440 grit and scotch-bright pad on the bottom of the primer slide assembly. Just knock off the high spots and polish whats left.

[gnihcraes]

Loosen the allen heads on the primer housing . Pull handle down so the primer cup is in shell plate. Then tighten the screws. Another minor issue is the large roller on the primer slide not moving when and where it should. I use a quick blast of silicone spray on the pin.

Back off the two screws that hold the primer assembly to the frame. Just a touch, like less than 1/8 of a turn.

Also, try running some 440 grit and scotch-bright pad on the bottom of the primer slide assembly. Just knock off the high spots and polish whats left.

Thanks for the tips. I did make sure the primer tube mount isn't too tight. The primer slide assembly is free and runs smooth, it's that dang rod from the primer tube to the rollers. It obviously rotates/twists just a bit during operation and it's binding in the guide/holder at the top connection at the block on the primer feed tube.

I polished up the top portion of that rod, filed down the end circumference a bit, just a tiny bit of a tweak on it's angle and I think it's running ok and staying put now. It moves in and out in that block and just keeps hanging up there. The angle of that block on the tube obviously makes a difference too. Yall know what I'm talking about. That rod appears to be just sheared when cut and the end was a bit out of round.

After test firing some rounds tomorrow, I'll get back on making some more. It appears to be operating ok at the moment after running it a 100 or so times while empty. Rod is moving, not binding and primer slide is doing it's thing.