paintless dent repair

[sniper7]

Some asshole smacked my truck with his/her door. Small dent size of a golf ball as far as area goes. Anyone do this or can recommend? How much?
I'll get pics in a few.

[MarkCO]

If you want to go cheap, set it in the sun and when the surface temp hits 150, spray with Microfreeze or Minus62. I spent an afternoon and fixed an entire Honda Accord that had been totaled ($5K) for 3 hours and about $30 of Minus62.

[jhirsh5280]

Ive heard heating it up with a hair dryer or heat gun then spray with an upside down can of air and the dent will pop right out

[sniper7]

Thanks guys. Pics sucks but you know what it looks like. Typical door ding. Not on a crease so that's good. Its on the bed of the truck above the wheel well and the good news is there is a drain plug in the wheel well below it. I just messed around with sticking a screwdriver in the hole and can reach the dent no problem. If it was nice and sunny I might mess with it.

[Kaiser.Shooter]

I know a good PDR guy, if you still interested I can find his phone number.

[sniper7]

If there is a small little crease did that come out with the pop method?

[MarkCO]

If there is a small little crease did that come out with the pop method?

I've been able to pull small creases with 2 to 4 times of the hot then Minus62.

Be careful if you use a heat gun, you can burn the paint.

[Robb]

I'm going to attempt this on my sons car. Do yo have a local source for Minus 62/Microfreeze?

[MarkCO]

An electronics hobby shop may carry it, or a similar product. I know Fistells down in Denver carries it. Amazon carries MicroFreeze and TechSpray. These products are basically for testing circuits. Most of them are HFC-134a refrigerant in an aerosol can.

[rockhound]

Mike Dunst

Dent Mirage
7202781659

tell him shane from Bailey sent you, he took 51 hail dents out of my avalanche, looks like brand new, has done work for several people i know and they all love the results.