What did you do in the shop today?

[Zach O]

Made 4 more steel target hangars. Needs some nuts for more, but town seemed really far away today.

I have 7 hangars now. Should have went shooting instead. What a nice day!

[encorehunter]

I built crossdraw holster for my Ruger Bearcat today. It has been swimming around in a oversized Hunter holster for too long. Now I should be able to wear it on my fourwheeler.

[ray1970]

Today I'll be out in the garage pulling the exhaust manifolds off my truck to replace some broken bolts. Should be a good time.

[Bstoker87]

I'll be taking one car back for storage and pulling the 68 Corvette to the center of the garage to star working on the 5.3 swap for my buddy.

[TEAMRICO]

I cleaned it......winters coming.

[gnihcraes]

Milled an 80%. Came out good, just need a LPK to find out how good.

[MarkCO]

Finished the prototype for a new handguard and a new shotgun tube configuration for the VMs.

[buffalobo]

Nobody working in the shop these days?

Replaced broken ejector in my RIA. Part from Armscor/RIA backordered forever it seems, Brownells got it to me in 3 days.

Pushed out the pin, dropped new one in, not even close. WTF. I ordered two to have one in parts bin for next time it breaks so I went after it with the dremel.

Not a fan of having to hand fit parts(afraid I will mess up something else in the process) but very pleased with results.



Slapped a cheapo magwell on the Canik to see if I like it before spend $75+.

[Great-Kazoo]

I'm working on a few blocks of AL, for the kids

[buffalobo]

Finally think I killed the FTE gremlin on my .22 bullpup. Only had a few minutes to test but ran 5 mags smoothly. Usually lucky to get thru a mag with out a stove pipe.

Need to run it for couple hundred rounds to see how it does dirty.

Looking forward to some Steel Challenge practice with it.