My guide pieces, using the grasshopper jig, weren't straight and when I put it in the press it caved in. Tried to straighten it out and didn't work, then noticed the bend wasn't even. So tried to make it a flat again amd ended up flattening out the top rails and just gave up from there.

I'm not going to use the press amd use the screw method to pull it through like the last one I bent. That one actually almost made it to be a complete ak until I failed to think out the way I was pressing on the rear sight and caved the entire reciever over.

Live and learn, hope this one is the last for the build.