Arsenal SAM7K-03

[Sabre]

Looks like Arsenal has made some nice improvements to the original SAM7K pistol. Anybody have/shoot one yet?

http://www.arsenalinc.com/usa/SAM7K-03-PISTOL.html

[Great-Kazoo]

If they weren't so proud of their product, i'd buy one and SBR it. Hard to do when i SBR'd my draco, $400 draco $200 stamp.

[USMC88-93]

If they weren't so proud of their product, i'd buy one and SBR it. Hard to do when i SBR'd my draco, $400 draco $200 stamp.

How hard to SBR? Do you just need to get a different rear riveted on the receiver.

[Great-Kazoo]

How hard to SBR? Do you just need to get a different rear riveted on the receiver.

i drilled & tapped 2) 8-32 holes for an ace adapter, little red loc-tite put, installed US mfg H/T/S flash hider, ace folding stock, pistol grip, MI handguards. Install loaded mag shoot & repeat. With the short bbl, yo would think the recoil might be a little noticeable. There's minimal recoil, for what there is.

[balyon885]

Same way I did my PAP m92.

[Great-Kazoo]

Same way I did my PAP m92.

I'm thinking of shit canning the MI hand guards, going with an AMD refinished set by BOBBYZZZZZZZZZZZZZZZZZ. I have a cut up wood butt ,stock. IF i was the master wood workerike we we have here, i'd figure a way to put it on, instead of the black furniture.

[balyon885]

Was a pain to get it to that, but I used the citrus strip, an iron, and a dark stain with some oil sealer over it. Took me a few tries and it never got as dark as I was hoping for. The only handguards that fit the pap are mi's and I wasn't going to pay that price.

[beast556]

That m92 looks bad ass!!! Nice job.

[zteknik]

I'm thinking of shit canning the MI hand guards, going with an AMD refinished set by BOBBYZZZZZZZZZZZZZZZZZ. I have a cut up wood butt ,stock. IF i was the master wood workerike we we have here, i'd figure a way to put it on, instead of the black furniture.

We can fix that
Just have to figure out how to graft the buttstock onto the folding mechanism and were golden

[Great-Kazoo]

We can fix that
Just have to figure out how to graft the buttstock onto the folding mechanism and were golden

Well after bouncing ideas off each other i will proceed as talked about. I really don't need the amd stock. Make my own base and mount, BAM! With the scope mount and charging handle interfering it will not side fold 100% . BUT it's all about the individuality. I could use a 10/22 or sks back section ,mmmmmmmmmmmmmmmm