Suspension thread

[newracer]

Nice work, looks great!

Almost picked up a 99 Rodeo for my kids last night. Motor didn't sound right so I passed.


Sent from my iPhone using Tapatalk

[Irving]

Yeah, they tend to eat oil.

[brutal]

Jeep stalker.

[Irving]

I can't catch them on trails, so I have to find them in parking lots.

[brutal]

Had to back him into a corner.

[newracer]

Yeah, they tend to eat oil.

It was "ticking" really bad. Power was good though.


Sent from my iPhone using Tapatalk

[Ramsker]

Looks great. I had a 98 Passport for years and loved it. Started to have some small issues at 185k and figured I was pressing my luck so traded it in. But it was a fantastic SUV--miss it sometimes.

Been reading through . . . props for doing all that work. I try to challenge myself with DIY where I can, but my confidence with vehicles is low. I wouldn't have a clue how to do any of that stuff.

[Great-Kazoo]

At another stopping point. The old torsion bars seem to be welded into the keys. I was able to easily knock off the control arm collars, but the keys are not moving a bit. They are going to soak all night in PB blaster and I'll see if anything changes in the morning. Right now the plan is to take them some where that can press them off for me. My trusted mechanic is unavailable right now, so I'll have to look around and find someone who can do what I need and hopefully not charge me a ton of money. After that, it's just six bolts and some adjusting.

Does anyone have a good source for where I can order parts to build my own quick disconnect sway bar links? EDIT: I need to order a couple of Heim joints.

EDIT 2: Looks like this site sells exactly what I need. http://www.use-enco.com/CGI/INSRIT?P...MPXNO=22569081

Now I need to figure out if I just want to use a piece of all thread (probably not) or find some studs that I can have welded together.

One guy I saw actually cut his front sway bar in half, then welded tubes on either side, and put a pin in a collar to hold the two sides together. When he goes to wheel, he just pulls that one center pin and the sway bar just twists independently on each side. Very cool, but I don't think I can hot link the photos onto this thread so you can see what I'm talking about.

If you ever need parts like this again, Rocky Mountain bearing, fastenal or Grainger. RMB is my first choice.
http://www.use-enco.com/CGI/INSRIT?P...MPXNO=22569081

[roberth]

It was "ticking" really bad. Power was good though.


Sent from my iPhone using Tapatalk

IIRC here was a factory recall on "ticking" in the 90s, i had a '95 and didn't do the recall, sold it a couple years ago. Solid truck and motor.

[Irving]

If you ever need parts like this again, Rocky Mountain bearing, fastenal or Grainger. RMB is my first choice.
http://www.use-enco.com/CGI/INSRIT?P...MPXNO=22569081

Thank you, I've been looking around and it seems like I can source parts for much cheaper.