Looking for some ideas and suggestions. I recently soaked my Surefire Socom RC in CLR to try an clean out some of the caked on gunk inside (it was 4oz heavier than new). That idea came from this thread:
https://www.ar15.com/forums/armory/C..._56/20-440940/

Minimal success in cleaning out the gunk, but now I'm trying to find a way to get the residual water from rinsing the can out. I've left it to dry in the house for a week and can still shake water out, tried using the air compressor with limited success - any thoughts? My next idea was to put it in the oven on a low heat for a few hours, but the better half isn't stoked on that idea. I could also be overthinking it, but I remember being told that shooting a centerfire rifle can wet was a bad idea due to pressure and increased baffle strike risk if the bullet was knocked off course.

Also, any thoughts on getting some of the crap out? Thanks for your time!