Basic Machining Help

[Rucker61]

I'm looking to pick up a CZ P10c, with an eye to using it for 3 Gun and carry. It comes with 15 round magazines, but evidently you can modify higher capacity CZ magazines from earlier handguns to work in the P10c. I'm looking for someone who can punch a hole in my existing magazines so they'll work and I won't violate any Colorado laws in acquiring extensions or new P9 magazines. The mod is pictured in the link below. I couldn't find a photo small enough to post.

https://hbindustries.net/store/wp-co...-P07-P09-2.jpg

[thedave1164]

Drill holes Each end and use a file to join the two holes

[ray1970]

Measure and mark with some calipers and a scribe, drill out the majority of it and finish off with some careful dremel work.

Unless of course you plan on doing a bunch of them. Then subletting the work probably makes more sense.