147 gr 9mm COL issue

[SSChameleon]

I went to get 147gr for 9mm subsonic and the only thing in stock were lead poly coated projectiles. I loaded two of them, and they won't chamber when seated at correct COL. I'm using unique powder, and I feel I seat the bullet deep enough to chamber, I'm well below the published COL and appear to have a compressed load.

i can reduce the powder charge to the minimum and wouldn't have a compressed load, but I'm hesitant to do this since I'm worried about excessive pressure. Is this a case where I eat the cost of the bullets and move on?

[buffalobo]

Looking forward to Hoser reply here. I think he loads alot of a similar recipe.

[Great-Kazoo]

what pistol and load data you using?

[DFBrews]

I went to get 147gr for 9mm subsonic and the only thing in stock were lead poly coated projectiles. I loaded two of them, and they won't chamber when seated at correct COL. I'm using unique powder, and I feel I seat the bullet deep enough to chamber, I'm well below the published COL and appear to have a compressed load.

i can reduce the powder charge to the minimum and wouldn't have a compressed load, but I'm hesitant to do this since I'm worried about excessive pressure. Is this a case where I eat the cost of the bullets and move on?

Which brand and profile bullets are you using

[SSChameleon]

Lyman load data, Anderson ballistics 147gr HP. I would be close to 1.000 COL to get it chambered

[Great-Kazoo]

Lyman load data, Anderson ballistics 147gr HP. I would be close to 1.000 COL to get it chambered

Average on other forums for 147 lead FN is 1.060. But the consensus is HP-38, as Unique is a little smokey. Also mentions a FN may not work, depending on ogive & chamber.

[Irving]

Fiat nose rounds need to be loaded deeper due to a wider ogive. May need to switch to a round nose.

[Rucker61]

I just loaded up some SNS coated 147 RN at 1.11, and they fit and fire in all three CZs and the Shield. Using 3.4 gr of VV N320.

[Hoser]

Try seating it deeper, but back off your powder charge a half grain or so.

If it doesent cycle the pistol or show much pressure, add powder until it gets where you are happy.