Here are some mods i have done over the years.

I use a Inline fabrication quick change mount. I mounted a small piece of metal angle hole/slotted to hold small bins.


Made an auto ejector for the indexing rod. It is a drill bit stop that i drilled and tapped twice. One for a retention stud and the other for the spring stud. With it tapped you can use a small stud to attach a couple of small springs.



With the the auto ejection there needs to be a feed ramp to channel the cartridge into the bin. I used a thin piece of aluminum to make the ramp.




I installed a inspection mirror to confirm that there is powder going into the case. Also Bought a roller handle from inline fab.


Took a piece of aluminum and cut it to hold a case bin. it is attached with two small "c" clamp.





Here is the press set up to run .223