Did a quick dry-assembly to check tenon fit. Man I've cut a lot of mortises and tenons on this.





Starting to look good. Almost good enough to leave in place and wish I were done. But the show must go on. Time to give the feet a little bit of shape.
Picked a random forstner bit that looked good in terms of size. Cut some holes in the base of the leg.


Over to the bandsaw. I planned to cut a bit of an ogive shape to it, but I didn't cut it very deep and I am not married to it. Might sand that part out.




I've drawn about 27 curves on the leg piece. Took it over to the bandsaw to see which one might look half decent.




Little clean up on the spindle sander.


Use it as a template for the rest of them.


Reasonably similar on all four sides.