The plug cleaned up reasonably nicely:




All the tracks in place:



Also decided to flush-mount the Inline Fabrication plate, which was a little more complicated. First, the receiver plate requires a fairly deep relief for the tail end of the press plate. Once that was routed, I had to route to the depth of the receiver-plate to inset it. The bottom of the plate has feet at the corners. I could have just routed everything to the foot depth, but I wanted as much contact with the bench as possible, so I tediously chopped where I needed to chop, and then glued in plugs where I messed up, until I got it reasonably flush-mounted:





Dragged my Co-Ax upstairs to test the plate. I have a Co-Ax, an SDB, and a 750 that I plan on mounting to the bench in an assortment of Inline Fabrication mounts.