6920 Trigger guard

[longbow]

I went to put a magpul trigger guard on my 6920 and the rear pin won't budge, I have done these before but this baby is set! and I sure don't want to damage the lower so I soaked it down with break free and let it sit overnight, any tricks or suggestions?

[BPTactical]

Make sure you use the CORRECT sized roll pin punch and support the ear on the lower. Look carefully at it beforehand, the factory may have sunk one side of the pin a touch deep and it actually is driven past the ear on the lower. If this is the case you will break the ear off of the lower if you attempt to drive it out from the wrong direction.
I have had to mill out pins and trigger guards in the past if they dont want to move.
If you dont get anywhere you can PM me but I wont be around a computer again till later this evening.
If in doubt- STOP!

[longbow]

Good advise..........I am rethinking the magpul...it ain't broke why fix it!

Thanks

[BPTactical]

Sent you a PM Longbow....