Yes, heavy anodize.. Well thats what appeared to me when I purchased a DD stripped lower and their parts kit. I installed the standard pistol grip from the kit but I good not slide it on very easily at all. It began scraping the lower receiver finish. I replaced it with a Miad grip then the screw was next.. The entire lower build was fine except for the grip and screw install. The screw did fit but after three turns of the screwdriver it was so tight it would go no further. I tried other grip screws from my LMT and Colt but had the same issue.

I looked at the threads of the screw and I could see the black anodize all over it. So I tried again but instead I worked it in then out and continued this process unitl it was completely in. The lower works great!


Quote Originally Posted by steveopia View Post
I remember reading somewhere that sometimes anodize gets a little "heavy" in some of the holes making it a tight fit.



$50? Shipping plus FFL right?