anyone here a HVAC repair person? My heat's out

[cebeu]

"...last night I cleaned the probe, changed the filter, checked all vents and reset the furnace a few times.

The furnace lights and blows for about 30 seconds and then I get an error message for "Inducer Motor" and after 3 or 4 attempts I get the high limit error

Too cold for this man...I had -10F at my place this morning...ughh... I chased a flame sensor issue myself ~2 weeks ago, PITA. My advice, pull-out the Installation Instructions manual and use the Troubleshooting Flowchart. More than adequate to get you to the field-replaceable unit level (part) or a source / fault problem (sensor limit or fail, AC/DC/Amps/ground, etc.). Pretty simple shit...just use common safety practices and common-sense re: power & gas. The down-side, if parts are required you have the "lag" to order/get them on-site.

Some value: http://arnoldservice.com/Troubleshoo...g_Problems.htm