Close
Results 1 to 10 of 12

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Paper Hunter d_striker's Avatar
    Join Date
    Mar 2009
    Location
    CO Springs
    Posts
    182

    Default Scope not parallel to bore

    I mounted my scope on my SPS Tac AAC SD a couple of weeks ago. I noticed then that my scope was "cross eyed" and pointing slightly to the left.

    I didn't think much of it then as I'm fairly new to long range shooting.

    I'm not sure if the receiver holes weren't milled in line or if the EGW base is off.

    What's the best (and cost effective) way of fixing this and getting my scope parallel to the bore?

    Adjustable windage rings?

  2. #2
    Industry Partner BPTactical's Avatar
    Join Date
    Dec 2009
    Location
    North Metro
    Posts
    13,899

    Default

    Well the first place to start is with the rifle. We need to make sure the mount holes for the base are axially aligned to the bore. If they are GTG then checking the base is the next step.
    Were the rings aligned before mounting the scope?
    Using adjustable rings is an absolute last resort.
    How did you ascertain the scope is not aligned?
    Has the rifle been bore-sighted?
    The most important thing to be learned from those who demand "Equality For All" is that all are not equal...

    Gun Control - seeking a Hardware solution for a Software problem...

  3. #3
    Paper Hunter d_striker's Avatar
    Join Date
    Mar 2009
    Location
    CO Springs
    Posts
    182

    Default

    Quote Originally Posted by BPTactical View Post
    Well the first place to start is with the rifle. We need to make sure the mount holes for the base are axially aligned to the bore. If they are GTG then checking the base is the next step.
    Were the rings aligned before mounting the scope?
    Using adjustable rings is an absolute last resort.
    How did you ascertain the scope is not aligned?
    Has the rifle been bore-sighted?
    I'm at work now and plan on taking it apart to examine the mount holes.

    I don't have any scope alignment rods and was just excited to slap everything on, zero at 100, and shoot a match.

    The axis mismatch is so severe that you can see it with the naked eye. That and I had to dial quite a bit of windage to get it zeroed.

  4. #4
    Guest
    Join Date
    Apr 2008
    Location
    Colorado Springs
    Posts
    59

    Default

    What rings are you using?

  5. #5
    Paper Hunter d_striker's Avatar
    Join Date
    Mar 2009
    Location
    CO Springs
    Posts
    182

    Default

    Burris xtr's.

    The rings are good. It's either the base or mounting holes.

  6. #6
    Guest
    Join Date
    Apr 2008
    Location
    Colorado Springs
    Posts
    59

    Default

    I thought the same about my set of xtr's. Turns out they were off center. A different set of rings was just fine. I've seen this same issue with three other sets of xtr's in the last couple weeks. Might be worth it to really look them hard. Mounted on a one piece base you could see mine were not in alignment. Hope maybe your set is better than mine was. They are going back.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •