The post whore thread.

[TheBelly]

My Sig 716P is 13.8 without the can and I'm going to be adding a SAPR when it gets here.

Have to re-weigh it but the glass is out at SWFA right now. Zoom ring post fell out unnoticed.

isn't that a piston gun?

[brutal]

isn't that a piston gun?

That it is.

Had to go back to Sig after 3 rounds and then FTE/FTF.

They polished the chamber, deburred the gas port on the piston block, and gave it a nice free trigger job. Got an extra mag back with it too (pre-ban).

Now it's mostly good although picky with some ammo (PCI) with the can hanging off the end. Won't cycle old M80 ball Greek reliably in any config. Just need to keep banging rounds through it and keep the chamber clean.

[TheBelly]

how's the accuracy? (assuming you'd be doing a litle precision stuff with it.)

[brutal]

how's the accuracy? (assuming you'd be doing a litle precision stuff with it.)

1-1.5 MOA with ball ammo. Closer to 1MOA with my first M80 clone loads. Closer to 1MOA with my old retired Marine friend behind the trigger.

.75-1MOA with GMM It's only a 16" bbl.

Haven't found the time to start a workup for all the components I have here for .308

Needed to order the the SAPR to get off the chin weld. That Larue QD mount is great for clearing the iron sights, but it's too high for a good cheek weld.

[TheBelly]

yeah, I use a LT158 on my 7.62 gas gun. It's.....a little high.

[brutal]

yeah, I use a LT158 on my 7.62 gas gun. It's.....a little high.

LT104 - even higher but I wanted to keep the BUIS on the rifles. Pretty sure LT158 would not clear them.

I don't think any mount on any flat top will really be low enough for me with a standard AR stock for a decent cheek weld. I must have high cheekbones or low eysockets.

[mcjhr]

It's 9 and 3/4 fingers sir!

[mcjhr]

Also good evening to you fine mini skirted gentlemen!

[TheBelly]

Also good evening to you fine mini skirted gentlemen!

Its a mini KILT, and its traditional!!

[TheBelly]

. I must have high cheekbones AND low eysockets.

FIFY