The post whore thread.

[SideShow Bob]

I think Kazoo is suffering from early frybrain syndrome, it tends to happen to everyone in AZ. sooner or later.

[OtterbatHellcat]

Only if you're in Phoenix.

[Great-Kazoo]

I think Kazoo is suffering from early frybrain syndrome, it tends to happen to everyone in AZ. sooner or later.

Honestly i wish it was that easy.

Every bank, ins company, health care, check books even the fuckin FEDS. all send shit to the physical addy.. Even after telling them by phone, a fax, email and snail mail letter DO NOT USE ANYTHING BUT THE MAILING ADDRESS!

Called the ATF today to see where my 5320.2's where since it's been 30+ days. WE sent them to (you guessed it) the physical addy. day 2 after i submitted the paperwork.
Well guess what maroon, i Clearly indicated what address the paperwork goes to AS Per your Help Desk. Well sir submit it in writing . Submit it in writing, how da fuck will that solve anything when you can't get it right electronically? Also who exactly has my information since you don't know where it is. Umm Ummm yeah i thought so. Time to back channel it through the nephew.

[ChickNorris]

Maybe try the designations: Billing & Shipping

[ChickNorris]

See you at 3:58 am!

Close, 4:24 ish

Odd. But what isn't.

[wyome]

I dunno

[ChickNorris]

Why not ?

: p

[brutal]

well shit.

Wiring up a new smart switch in a double gang box and I smoked the existing one pushing wires back in hot (yeah, I live on the edge.)

NP, I just grab one of the other new switches I picked up and it no worky (in the same 3-way config), WTF?

Turns out the new and old switches work different in 3/4/5-way setups. Now it seems I let the smoke out of a new switch using it the same as the old. Relay switches internally but nothing out the load or traveler terminals. Fawk...

Screw this, I rewired that 3-way back to a standard traveler setup and put manual switches back in. I'll figure it out later.

(turns out that with the old model switch, while I had to re-wire both ends and use neutral on the load end as the common to make it work, the new switch is more like a standard 3-way that just uses the same line-common to load-common remote, traveler and just picks up a neutral from the neutral tie at the line side switch to energize the smarts.

[Irving]

well shit.

Wiring up a new smart switch in a double gang box and I smoked the existing one pushing wires back in hot (yeah, I live on the edge.)

NP, I just grab one of the other new switches I picked up and it no worky (in the same 3-way config), WTF?

Turns out the new and old switches work different in 3/4/5-way setups. Now it seems I let the smoke out of a new switch using it the same as the old. Relay switches internally but nothing out the load or traveler terminals. Fawk...

Screw this, I rewired that 3-way back to a standard traveler setup and put manual switches back in. I'll figure it out later.

(turns out that with the old model switch, while I had to re-wire both ends and use neutral on the load end as the common to make it work, the new switch is more like a standard 3-way that just uses the same line-common to load-common remote, traveler and just picks up a neutral from the neutral tie at the line side switch to energize the smarts.

Oh man, what a stupid idiot.

I feel like if I don't put in this smilie, the thread will implode (even though it probably wouldn't).

[ChickNorris]

Night folks