Gunsmith for Glocks?

[JackImpact]

Im looking to make a few changes on my Glock 19. Id like to get the 3.5lb connector, extended slide release and have the trigger parts polished to make it a bit smoother. Was also considering an extended mag release, but not sure yet.

Also, wanted to buy a punch so I could learn to fully take down and put back together my entire Glock.

Anyone know of someone in the Arvada/Denver area?

Thanks!

[cstone]

BP Tactical He is an Industry Partner on this board. He is located near 104th and Washington. Excellent prices and service. I wouldn't use anyone else. YMMV

[cofi]

i wanna do all these things to my glock 30sf lemme know who you end up going through

[Delfuego]

You could always go see Rob at Bowers, he my even have all the parts in stock!

[JackImpact]

You could always go see Rob at Bowers, he my even have all the parts in stock!

Bowers?

[Delfuego]

Bowers Tactical in the DTC. They are a partner here and good people.

http://www.co-ar15.com/forums/forumdisplay.php?f=120

[co80112]

crap dude, its 3 pins, i had my glock apart within 30minutes of her getting home, try youtube save your money, its sooooooo easy
i can show you in about 3 mins if your in south denver, MAKE SURE ITS NOT LOADED!!!

[co80112]

one final tip, it helps to wiggle the slide release and or trigger when removing the big pin, sometimes it binds, muscle isnt the way, and when putting it back together the top pin goes first or it will catch the spring, tits!@

[BPTactical]

To the OP- check your PM's.

Attempting repairs/modifications on your own if you are not familiar with the function/disassembley of your firearm can be a recipe for disaster. I would be happy to have you bring her over and give you the nickel tour of your firearm.

[kwando]

I've done extended mag and slide release = cake
$.75 polished internals = cake

never done 3.5lb connector but i can't imagine it being hard.

learn your firearm and save a few bucks.