SMooth.................
I bet that one smarts.
as a side... anyone know what I should do about a "loose" pin on the barrel link of my colt MKIV ? is there anything I can do ?? it falls out when I disassemble and heck sometimes slides partway out during assembly ... very annoying .
DAMN!! Watch out for that recoil spring.
Yup-easy fix- take a nice and sharp center punch and "stake" the pin in place. On the outside of the lug where the hole is place the point of the punch just outside of the hole with the pin in place. Give it a sharp rap but you are not trying to drive the punch through the lug. The punch mark should upset a smidge of lug metal into the hole, holding the pin in place. Repeat for the other side. Stone any burrs flush with the lug surface.
If you are not sure/comfortable taking a hammer to your 1911 give me a shout. I hammer goodly!
The most important thing to be learned from those who demand "Equality For All" is that all are not equal...
Gun Control - seeking a Hardware solution for a Software problem...
My god Alex. As one that grew up with them and had them in my arms room I did have a couple of Docs that almost got hit but never seen that one.
If you ever decide to buy A fal and think "oh, I will just undo this screw in the buttstock" please call me before half your head is taken off.![]()
I see you running, tell me what your running from
Nobody's coming, what ya do that was so wrong.
I see you running, tell me what your running from
Nobody's coming, what ya do that was so wrong.