Several years a go I won a set of TnT Guardian Sliders. I finally got around to installing them the past few weeks. These are aluminum with a UHMW skid. They are way lighter than the Poison Spyder ones I previously had.

The main reason I procrastinated so long was I would need to instal high clearance body mounts with the sliders since I have a 1" body lift. My mounts were in bad shape from hitting rocks so they really needed to be replaced anyways.

In this pict the middle mount is done and the rear old one has been cut off.



All three new ones in place.


Threw on some paint.



Get the slider in place, my Poison Spyder corner needed a little trimming to match the slider.



Drill and bolt it in place, then drill and tap the holes to mount the UHMW skid.



Passenger side.



Actually the install wasn't bad just a little time consuming. I really like that my body mounts are now higher and protected. The only downside is that I could not tie my A pillar cage mount into the frame as there was no room with the slider in place.