Need a competent AR-15 gunsmith in Denver

[Sticks]

BPTactical it will be then.

My sizing die is a Dillon RT1200 setup on a Lee LoadMaster - bottomed out on the shellplate. No problems with the first 4k that I have made, it's just this last batch. Might be that I need to have .005 - .010 trimmed off my die base for a little more fluff room.

Last night I went through 500 rounds and culled out 25-30 that were .006 or less above my case gauge max - those were causing a FTF and stuck bolt. Even the ones that are flush with the case gauge max require a fairly stout pull to release the bolt. I need to go through another 300 or so to finish my training class....Yes I am firing this rifle for this class. Not wise? likely, but I want to learn how to run a scoped DMR in a tactical CQ situation. PRS stocks bite back when you have to mortar them.

[agentutah]

Best steps to start from scratch on an AR build

[82ndShooter]

Go see Bert @ B&P Tactical. He is the best gunsmith I've dealt with ever.

[Sticks]

TD2 went without a hitch, except for having to double handed pull a couple for manual unload/extraction. Might have had a few sneak by that were a tad over max length.

This may turn into a deal with it during lay off. Going to try for next weekend. Will make some calls.