any welder in Colorado Springs area?

[colo-pr]

Hi guys because im new in the area i dont have an idea where to find a welder for a simple modification in the rack of my Jeep.

if anyone know someone please let me know, im looking for GC=Good and Cheap

thanks in advance

[baglock1]

Are you looking for someone to do the work or do you just need access to a welder? I've got a 120v Hobart wirefeed you can use but as a rule, I don't do welding for people I don't know that well (liability). Given how long it's been since I've done any serious welding, you likely don't want me splattering booger welds all over your Jeep anyways.

I've pushed it to 1/4" for non-structural and 3/16" for something that needed strength. It did the Ford 8.8" and fullsize D44 swap on my old CJ-7 without any trouble. Are you just adding some light tabs to the rack or something?

[dwalker460]

Bring it to Denver and I can help you out.

[colo-pr]

Bring it to Denver and I can help you out.

thanks dwalker460, im trying to find something closer but if lot lucky i will contact you

[Tim K]

Try this guy. You'll need to PM him.

http://www.ar-15.co/members/5898-Colorado_Outback

[Colorado_Outback]

Try this guy. You'll need to PM him.

http://www.ar-15.co/members/5898-Colorado_Outback

Thanks Tim.

Shoot me a message colo-pr, I can get it sorted out for you maybe this weekend or some time next week.

[colo-pr]

bacglock1

thanks but im looking for some one to do the job and i pay, not too much but pay for the work no more than the price of the rack lol, i have not experience welding, the mod that i need is simple, let me explain you. I bought and install from warrior the "Adventure Rack" and this rack comes with 2 areas in the side to carry gas cans but is made specified for original Jerry cans, i already bought 3 different cans but wont fit in the area. The only that i need to do to my cans fit is remove an edge (i can do it for with my grinder) and welding a maybe 2 inch of the same metal for extend the platform. Because my english is not the best i include here a picture with the idea.

this is the rack:

here is my jeep and i need to remove the edge of this area and extend the area maybe 2 more inches in order my can fit there