Quote Originally Posted by SNAFU View Post
Well you have 150,,got 1000+ myself,,,don't know how the "k" got there.
My Wnchester M1 Garand gets loaded by ENBLOCS
Technically, it gets loaded using enbloc clip --- unless you'd like to argue with FM23-5:

3. Description of the RifleThe U.S. rifle caliber .30, M1, (fig. 1) is an air-cooled, gas-operated, clip-fed, and semiautomatic shoulder weapon. This means that the air cools the barrel; that the power to cock the rifle and chamber the succeeding round comes from the expanding gas of the round fired previously; that it is loaded by inserting a metal clip (containing a maximum of eight rounds) into the receiver; and that the rifle fires one round each time the trigger is pulled.


12. Loading the Rifle(a.) Single round. To load a single round, pull the operating rod all the way to the rear. While holding the muzzle below the horizontal, place a round in the chamber an seat it with the thumb. With a knife edge of the right hand against the operating rod handle, force the operating rod slightly to the rear. Push down on the follower assembly with the right thumb and allow the bolt to ride forward. Remove the thumb from the follower assembly and release the operating rod handle, allowing the operating rod to go all the way forward.
(b.) Full clip. To load a full clip, hold the rifle at the balance with the left hand and pull the operating rod handle all the way to the rear. Place the butt of the rifle against the thigh or on the ground. With the right hand, place a full clip on top of the follower assembly. Place the thumb on the center of the top round in the clip and press the clip straight down into the receiver until it catches. Swing the right hand up and to the right to clear the bolt in its forward movement. Note that the operating rod is not held to the rear during loading since there is no danger of it going forward as long as pressure is maintained on the top round in the clip. It may be necessary to strike forward on the operating rod handle with the heel of the right hand to fully close and lock the bolt.
(c.) Partially filled clip. To load a partially filled clip, hold the rifle in the same manner prescribed for a full clip. With the operating rod all the way to the rear, place an empty clip into the receiver. Place the first round into the clip and on the follower, to the left of the follower slide. Press the second round into the clip, exerting a downward, turning motion until the round snaps into place. Load the remaining rounds in the same manner. With the knife edge of the the right hand against the operating rod handle force the operating rod slightly to the rear. Push down on the top round with the right thumb, allowing the bolt to start the top round forward. Remove the right hand and allow the operating rod to go forward.


14. Loading Rounds into a Clip
(a.) Insert eight rounds into the clip, holding the clip, open end upward, and the rounds in palm of your left hand. Start placing the rounds in from the lower left of the clip and make sure that each round is against the rear wall so that the inner rib of the clip engages the extracting groove of each round. The top round will then be on the right, making the clip easier for a right handed firer to load in the rifle. For the same reason, clips are loaded this way at arsenals.
(b.) Each time rounds are loaded into a clip, the clip should be checked for long rounds. If one rounds extends beyond the others, it will be hard to load the clip into the rifle. The long round should be seated by removing the top round, pushing the long round into place and then replacing the top round. Tapping the bullet against a solid surface to seat the long round may result in the bullet being pushed back into its cartridge case. This may damage the bullet or break the bullet seal which could result in changes in the ballistic performance of the round.