New Fort Collins gal...

[Delfuego]

Welcome aboard.

BCM upper, BCM 14.5" LW barrel, battlecomp 1.5"

I got one of those and it works great!

[StagLefty]

Welcome aboard

[islandermyk]

dang... talk about whoring it up in here sh*t...


how about some pictures or a pic..... of the AR...

[Fentonite]

Jeez! Did anybody notice how many views this thread has in just a couple hours? We have some despera.... I mean, welcoming members here!

Anyway, welcome!

[10mm-man]

I would be terribly offended if everyone were on their best behavior...life is so much less fun that way!

By the way, just a fun video we shot of me firing a shotgun for the first time a few months ago. Keep in mind that I had never fired a shotgun before, let alone a bolt action. I'm much better with it now.
http://youtu.be/V31gIigLISA

Welcome aboard! You looked like my son (he is 10 y.o.) today firing a shotgun for the 1st time- All SMILES! Glad you like firearms and good to see a gal on here...........

[drocra]

how about some pictures or a pic..... of the AR...

Can do!


Upper:
Bravo Company Upper Receiver
Black Dawn BCG
Bravo Company 14.5" Mid Length Lightweight Barrel
BattleComp 1.5" Compensator
Magpul MBUS BUIS (ignore placement in pic; that will be fixed once I have somewhere else to put the front sight...)
Bravo Company low profile gas block/generic gas tube
Magpul AFG2
Bravo Company Gunfighter Charging Handle, medium latch
Midwest Industries 9" Mid Length Gen 2 SS Series one piece free float handguard, OD green/Midwest Industries handstop (not pictured; hurry up, MI!)

Lower:
Rock River Lower Receiver
DPMS Lower Parts Kit
Magpul PMAGs
Magpul BAD lever
Magpul CTR Stock, OD Green
Bravo Company Stock Hardware Mounting Kit
Magpul MOE-K Grip, OD Green

All I'm waiting on is my hand guard. Then it will go something like MI barrel nut -> gas block/tube -> weld/pin compensator -> hand guard. all that waiting for one freaking specialty barrel nut.

I didn't run into too many issues with assembly, although the DPMS takedown pins are tight as hell. It took some oil and elbow grease to get them to the point where they're removable without a punch.

[One Shot]

Welcome to the forum!

[pickenup]

Howdy

[Big Wall]

Welcome!

[BuffCyclist]

Welcome! Nice looking rifle, but the sight radius on those BUPS is a little short...


eta:

I didn't run into too many issues with assembly, although the DPMS takedown pins are tight as hell. It took some oil and elbow grease to get them to the point where they're removable without a punch.

I just assembled a spare M&P15 lower with a CMMG parts kit and the takedown pins were the same way. I can barely snap the front pin all the way in without the use of two hands, it stops with about 1/8" left of travel.