What did you do in the reloading room today?

[Zombie Steve]

Built another shelf and tied some storage cabinets to the wall. One of these days I am actually going to pull the handle a little.

What was that song? 50 ways to love your lever?

[Zombie Steve]

I cast some .44 boolits, then took on the task of opening up the cavities on my stupid new Lee mold. They were dropping from the mold at .450" - .4515". After turning some oversized boolits with some bore bright, I boiled the block, cleaned it with rubbing alcohol, and it still took about 100 drops to get pretty boolits again.

Damn you, Lee!!!!

[bobbyfairbanks]

Put in a new door. Had to do some reframing of the doorway. Load bearing wall was 3" off plumb

[Prong]

Banged out 200 rounds of 223 and stuffed them in Pmags. Need to buy some more 50rd MTM boxes to finish up the rest of the brass for storage.

[Marine24]

Three guesses what I did. Yes, deprimed. I'm starting to think I'm like Bobby and will never get through with the prep. Actually realized that depriming LPP with the Harvey deprimer is much faster than SPP. Flying through 45 ACP and 454 Casull until I hit one of those SPP 45 ACP brass.

[gnihcraes]

.308, Hornady 168gr BTHP, 42 grains Reloader 15.

[Marine24]

Excellent load. One of my favorites for my 700 AAC-SD.

[ColoWyo]

Sonic cleaned my .260 brass. They sure look prettier.

[sellersm]

Built some shelves, working on some 9mm gold dot loads. Need more shelves but can't find any more brackets... Too cheap to go buy some. Gonna start some 357mag loads & forget the shelves for now.


Sent from my fat fingers using Tapatalk

[jerrymrc]

Rookie mistake...
Attachment 25305

Attachment 25307

I will take all that berdan .308 from ya.