What did you do in the reloading room today?

[Great-Kazoo]

Couple hours total. Granted I made coffee, played in the snow with the hounds, ect. The 1050 is a pretty simple machine to tear all the way down.

It runs me an hour to do a complete tear down & service on the 1050. Looking at it, one would think it's a complex press. Once apart a few shafts, bearings etc, good clean up and inspection parts, fresh grease then back up and running. Dillon did a nice job on the 1050, reminds me of a motorcycle bottom end.

[Limited GM]

Tore down two of my 1050s all the way, cleaned them all up, repacked the bearings and reassembled. I was going to do the same to number three 1050, but got bored and went back to loading rifle ammo on my 550. 223 Ackley and 6 Grendel with Varget.

You were wise to not have me meet you at your house. Fugger.

[KS63]

Cleaning the 550 and removed the indexing ball so it could drop in to no mans land in the ram. Thought about leaving it there, but being OCD, I magnetized a Torx driver and retrieved it. Replaced with a plastic unit from Hit Factor.

[Alpha2]

I walked THROUGH the reloading room today, to get some tools and hardware for the installation of the new fridge and freezer. Sometimes, I need to do "homer" shxxxx...stuff.

[encorehunter]

Poured up over 1000 9mm 124s and another 1000 or so .45 acp 200s. Hope to powder coat tomorrow.

[eneranch]

Working-up loads for a new barrel; I'm close, I think

[stodg73]

Cleaned up all the media that was on the floor under the bench,

[Great-Kazoo]

tumbling 223 brass, got 400 rds 158gr lswc 38 spl. out of the way. Possibly another 1K brass today along with 4-500 38 spl. to finish out the lead sitting here.

[Slapps74]

Took down all the fluorescent lights and replaced them with the LED's the wife bought me for Valentine's Day.

[USMC88-93]

The great semi-annual reloading binge has begun, have 5000 pieces of brass to process and have made it through around 1200 so far. I wish I could justify a progressive but I do not reload frequently enough. I can make them look good though.
Now I just need to decide if I want to load as a plinker round, a jack of all trades round, or load it all for my high power competition rifle......