What did you do in the reloading room today?

[Hoser]

Got the Aztec function up and running on my AMP Annealer. Pretty cool. No more sending brass away to have the factory figure out settings.

[whitewalrus]

That's about $120 at your local scrap place. Probably much more, like close to $150+.

Didn’t know that scrap places would take spent primers, guess I should have been throwing them in a bucket instead of in the trash.

[Hoser]

Spent a few hours this week reloading 223. Took one 5 gallon bucket of brass and turned it into ammo. Killed more than a couple 8lb jugs of Varget and most of a case of Hornady 55s.

Somewhere around 4,500 rounds.

I hope to not have to reload 223 for a long time to come. And now that I have done it, I hope to never decide to do something as stupid as deciding to do that again. Just because I have a bucket of processed brass doesn't mean I have to do something with it. It was just fine testing gravity.

[thedave1164]

Picked up 8lbs of H4350 for the 260

[Irving]

Did 200 rounds of 9mm the other night.

[rondog]

Didn’t know that scrap places would take spent primers, guess I should have been throwing them in a bucket instead of in the trash.

Oh yeah, they'll take 'em!

[Shooter45]

More 44 magnums loaded up for the weekend

[mattiooo]

BobChute was delivered today. I think I will drill out the cap on a cold coffee bottle for it. They have a more stable base than a soda bottle.

[longrange2]

Does Koscove also sell? I’m looking to pick up some pure soft lead to mix with wheel weights. If I am selling off brass and aluminum for scrap it would be nice to plow the money back into lead

[Hoser]

Pulled apart one of my 1050s and changed it over to load 308 and loaded a few hundred rounds. Throwing about 47 gns of Benchmark under a 125 TNT. Fun gas gun load, but I hate loading 308 compared to 223.

I thought I had a 308 FL carbide die, but it was a carbide trim die I had ordered. Guess I will be calling Dillon.