I recently got a miller 120. Its an older 240v welder but not too old. 90's I think. I learned how to stick weld in high school and then had a gas-less mig. I would not consider myself a great welder but i would feel comfortable with my welding capabilities to weld car frames and stuff.
That being said, I feel like a complete idiot. I cannot get a decent weld to save my life with my new miller. Its got a tank (no idea where to set the gas to) I was told between 15 and 20 cfm. I have no idea what wire is in it (its silver not copper colored). I have my heat turned to the 2nd position (2 of 4) and my wire speed pretty low. 30 on a (10-100) scale.
This is what is happening. I am getting splatter all over the place. So bad that if I do get a good weld it looks like shit because of all the splatter. Does anyone have any suggestions?