NFA questions (newbie)

[kwando]

Just read of horror stories about engravers screwing up lowers, and needing to change the lower. I guess if choosing a good engraver that knows what they are doing its less of a worry.

Barrel makes sense I was just trying to acquire one first instead of waiting even longer for one if the barrel is OOS

[Great-Kazoo]

Just read of horror stories about engravers screwing up lowers, and needing to change the lower. I guess if choosing a good engraver that knows what they are doing its less of a worry.

Barrel makes sense MY FRIEND was just trying to acquire one first instead of waiting even longer for one if the barrel is OOS

BBl's are no problem. I suggest an 11.5 for a short one . This way once you get the stamp approval for your suppressor [ yes you'll have one sooner than later] it should run with little if any issues. I have not had any on the 11.5's i run. Most suppressor mfg suggest a 11.5 to avoid "potential" issues as they might happen on shorter ones. I know a few running supressed 10" uppers.
Upon you FRIEND getting approved, IF he cannot locate a bbl have Burt cut, thread and recrown one.
Remember Look for solutions, Not Problems.

[kwando]

Build a pistol lower how he is going to have the rifle set up while he waits for the stamp to come back no constructive intent

i have a couple pistol lowers and 3 different short uppers

Lower is already assembled as a rifle from MY understanding it cannot be a pistol, again I am no expert.



Thx for the reply Ray, Rod and Jim!!

[Great-Kazoo]

Lower is already assembled as a rifle from MY understanding it cannot be a pistol, again I am no expert.



Thx for the reply Ray, Rod and Jim!!

Did you buy the lower NEW or used, assembled? I have a stripped lower that was sold as OTHER, and yes i'm over 21[physically]