PDA

View Full Version : Heading out to hunt steel - Prime ammo



Blowby
05-24-2017, 07:56
Time to acquire DOPE for the 130grn 6.5 Creedmoor ammo.
http://powerstrokearmy.com/photopost/data/542/medium/IMG_8915.JPG

The ELD-M147's were impressive but looking for a little more MV. Hoping for 2,840ish speed with these little pils.

http://powerstrokearmy.com/photopost/data/542/medium/IMG_9293.JPG

Great-Kazoo
05-24-2017, 08:14
Looks like a fairly steep area you're in.

Zach O
05-24-2017, 09:28
Barrel length?

Blowby
05-24-2017, 09:35
24" with TBAC CB30 9" Zach.

Zach O
05-24-2017, 09:38
Shouldn't be a problem. My daughters 22" is at 2870.

Blowby
05-24-2017, 12:25
Avg is about 2800-2810 (tel:2800-2810) today. (1,850 rounds through this barrel).
20+ mph wind and the best SD was 15 and 19 for this 5 shot group using factory ammo.
I ran them through the seating die to a 2.155 to ogive. Also tested other lengths but 2.155 was the winner with the Magnetospeed installed. Going to run without in a few. Need to work on my tripod shooting now because it sucks.

http://powerstrokearmy.com/photopost/data/542/medium/IMG_9439.JPG

Shot below with turrets at zero (above was .2L) with magnetospeed removed. Not much change in elevation. Dang wind!!!

http://powerstrokearmy.com/photopost/data/542/medium/IMG_9452.JPG

So so far the prime ammo is shooting well. Only got out to 700 yards with a 4.4 mil elevation and 1.5-2.2 mil wind hold left based on indicators. Need to be run these through the seating die for consistent length and test again with minimal influence from wind.