PDA

View Full Version : Superior Arms Lower



Troublco
04-28-2010, 19:04
I just got a new Superior lower that has the rear takedown pin detent hole bored too far in, and it appears to be slightly angled in too. I got the upper and lower together with a little fiddling (Couldn't figure out why to begin with) and then discovered that I couldn't swing them open. It was locked tight. Taking the stock off and checking everything from the back didn't help. I managed, with help, to get the halves apart after pushing out the front pin and having a friend hold the upper as I pulled on the lower, as carefully as I could. It still took material off the lug in the back of the upper. As I looked at it after seeing the material taken off the lug, I noticed that the rear pin wasn't far enough out, and wouldn't go out any further. The hole is noticeably off center towards the inside of the receiver, and as I said looks to be slightly angled. I'm sure Superior is going to take care of it, I'm just curious if anyone else has ever had this particular issue. Anyone?

Marlin
04-28-2010, 19:19
One of those thing I have heard of it, just never had it happen to me..