MagWhore

[hatidua]

What's up with people who only want USGI mags for their AR?

Legally speaking, it's a bit of a moot point isn't it?

[Bailey Guns]

Thanks, Jim. At least someone was paying attention.

[Gman]

I have made my past purchases looking for USGI teflon coated mags made on Labelle Industries tooling. I've never had a single failure with any of them. I picked up some PMags before the new laws went into effect, but I've yet to use any of them.

[RonMexico]

My mags of choice. PMag, HK mag than GI Mag. If it's a GI I put Magpul followers like Ray and a few others have said. GI mags will not run in SAW but HK mags will run in a SAW and IAR but are heavy and the feed lips bent easy if dropped.
You life is not worth $10 so throw the shit away or trade it for junk but bang for the buck I tend to go with PMAGs.

[Great-Kazoo]

My mags of choice. PMag, HK mag than GI Mag. If it's a GI I put Magpul followers like Ray and a few others have said. GI mags will not run in SAW but HK mags will run in a SAW and IAR but are heavy and the feed lips bent easy if dropped.
You life is not worth $10 so throw the shit away or trade it for junk but bang for the buck I tend to go with PMAGs.

get anything this weekend?

[hghclsswhitetrsh]

I just replaced most of my opened usgi mags with the new yellow follower from magpul. I like em both.

[RonMexico]

get anything this weekend?

Going back up with another buddy tomorrow . Truck problem and the gf had a limited schedule, so no

[Kraven251]

Personally I like pmags, but to that point I add the following caveats:

1. I have never served in the military or used a GI mag in any combat scenario
2. I like the feel of the PMag in my hand over the GI mag
3. I have put less than 500 rounds through a rifle using GI mags
4. I like the Barbie dreamhouse color selection with PMags

None of these things have anything to do with their functionality, durability, or useability; it is just my preference based largely on personal aesthetics, and what was available when I was having my rifles built out.